So with the help of a couple of my neighbours we uncovered the tub and started to lift it to the other side of the street where my garage is. It was surprising how heavy the tub actually was, i know many hands make light work... but i didn't have many hands only two other people, so many many thanks to Tony and Eric.
So we lifted the body round and placed it beside the chassis, i had previously cut holes in the tub for the gear stick and the fuel filler and fuel sender, so this gave the clearance for us to basically lift the tub high and lower onto the chassis, aligning up as best we could.
The body fitted nicely in place and most of the attachment points aligned with only a couple that will need opening up to get the bolt through. So were starting to look like a car now. Hopefully this will help the passing traffic that stops and says "what are you building?"
The body will be removed again just prior to permanent fixing, as the tub is also bonded on to the chassis. I will also be removing all the protective plastic off the stainless steel engine bay cladding, and cutting all access holes/panels that i will need.
So now the tub is on, i can start cutting more holes for the sidepipe headers to fit to the manifolds. This was a scary thing to do. But the basic rule of cut little at a time and open up slowly. I started off with using a straight edge to follow the length of the manifolds to touch the inside of the body tub. I then drilled a 2mm hole in each corner to give me a rough guide on the outside of the body. I then simply drilled a bigger hole in the middle and started to open up the hole with a jigsaw. The initial length and width was about 4inch square to allow me to slide the headers in and slip on to the manifold, then just a mark and cut procedure (about 5mm each time) until i had the exhaust fitted, with a good enough clearance around the headers as so they wont melt the tub when they a hot.
I tidied all the edges using a flap wheel and low drill speed, making the cuts look straight and even. Now the exhausts were back on i could do another engine run. I did have to space the fuel filter out from the chassis a little, as the fuel feed in was catching on the body tub, so better safe than sorry. Apart from that just a few things on my snagging list to sort and were getting somewhere.
I also received a visit from a fellow builder Ian Cogdon this week. He is on the correct side of the Tyne and is building a Pilgrim Sumo. He mainly came to see the engine running but i had only just fitted the body and had not cut the holes for the exhausts, so i couldn't run with just the manifolds, as they would have melted the body... so sorry Ian, next time for sure!!!!
Here we have another video of the engine rumbling away to itself when the tub is on. This now looks and sounds amazing, and is a massive milestone in the build process for me.
